My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: dodjh on August 08, 2012, 08:10:43 PM

Title: Tire lug nut removal
Post by: dodjh on August 08, 2012, 08:10:43 PM
Hi....I read a forum post about front end right side RT (reverse thread) lug nuts and other side different lug nut

removal.

Was that about the tires or the spring hangers?

I was just trying to remove driver side front tire and my impact driver couldn't budge the nuts...so I went

to a breaker bar and broke the yoke swivel on the breaker bar.

Then I remembered the different pattern for something.....

Is the lug removal different for each tire?
Title: Re:  Tire lug nut removal
Post by: bretto on August 08, 2012, 08:59:28 PM
If there is a 'R' stamped on the end of the lug its a right handed thread (counter-clockwise to loosen), 'L' stamp for left handed thread (clockwise to loosen).  If there is nothing at all stamped, its a good chance the are right handed threaded stud that were changed at one time since that is what is standard now.
Title: Re:  Tire lug nut removal
Post by: dodjh on August 08, 2012, 09:23:01 PM
Well my front driver side lug nuts are left handed.....didn't notice any stamp but will look when removing the other

three (3) tires.
Title: Re:  Tire lug nut removal
Post by: Carls_jeep on August 08, 2012, 10:11:35 PM
The drivers side lugs are left hand and the passenger side is right hand. On the end of the lug the Lugs may have a L or a R if they are original type.
Title: Re:  Tire lug nut removal
Post by: dodjh on August 08, 2012, 10:55:18 PM
Carl....there are so many shades of paint on them, I will have to wire brush them down to see.

I measured the drums and they are 11".
Title: Re:  Tire lug nut removal
Post by: Bob W on August 09, 2012, 05:58:50 AM
Left thread lug nuts may also have a line indented in them as an identifier.