My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Shalka04 on July 26, 2012, 08:22:13 PM

Title: Air Cleaner Cleaning?
Post by: Shalka04 on July 26, 2012, 08:22:13 PM
Today I set out to work on my Donaldson Oil Bath air cleaner.  I undid the clamp band around the bottom bowl and stodd there with anow what kind of though.
Is there more that can and should be taken apart to clean / restore.
I was eye ballin the can like filter element up in the main body wondering if I should try and pry that out.
Does it come apart more or should I just clean up and work with what I have?

-John
Title: Re: Air Cleaner Cleaning?
Post by: Gunslinger on July 26, 2012, 08:36:20 PM
John,
There is a good article on Bob Westerman's page about the Donaldson Air cleaner, I highly reccomend it, in fact its so good it should be nominated for an award, and yes, I wrote it... You can not and should not try to pry the mesh element out of the air cleaner, it does not come out.  All you need to do is submerge the metal element in kerosene or diesel fuel and flush it out, I don't reccomend gas, too volitile and I like my friends just the way they are, RAW, not over cooked.  After its clean, clean out the bowl and squirt some clean oil on the mesh, fill the bowl to the right level with good clean oil and your good to go.  These air cleaners are pretty old technology, but they really work, in fact we just started selling dry paer filters to tractor manufactureres in India about 10 years ago.  They were putting oil baths on new vehicles up until then... Yes, I work for Donaldson..
Title: Re: Air Cleaner Cleaning?
Post by: rocketeer on July 27, 2012, 07:26:15 PM
http://www.cj3a.info/tech/aircleaner.html

Larry