My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Quebec Jeep on July 05, 2012, 10:37:27 AM

Title: Bendix Joint
Post by: Quebec Jeep on July 05, 2012, 10:37:27 AM
I should have red old post about it before going forward and try to fix it. I learned it on the hard way.
So while trying to replace the knuckle seal...I found out that it's possible to get the axle shaft left/right front fall apart in your hand if you go too far away with the steering knuckle.

Now I know that I have bendix style joint on my jeep!

They are not looking too bad.

(http://pages.videotron.com/lavoip/index_files/Forum/BJ3.jpg)

But the front right one has broken spline. I'm also concerned with the mark and pinch on the axle.

(http://pages.videotron.com/lavoip/index_files/Forum/BJ1.jpg)

(http://pages.videotron.com/lavoip/index_files/Forum/BJ2.jpg)


What should I do? Replace it? Keep it? Try to find out the other piece in the differential?



I also have a broken yoke. It was already broken when I dismantled it so I think I will keep it like this and put back on my jeep. what do you think?

(http://pages.videotron.com/lavoip/index_files/Forum/Yoke1.jpg)

(http://pages.videotron.com/lavoip/index_files/Forum/Yoke2.jpg)

Thanks
Pascal
Title: Re: Bendix Joint
Post by: Macgraham on July 05, 2012, 05:30:53 PM
How does the surface look where the seal runs. If its rough you can use a speedy sleeve or replace it. This is on the yoke.
Title: Re: Bendix Joint
Post by: rocketeer on July 06, 2012, 07:20:36 AM
That's only a small piece missing but it could cause centrifugal imbalance at highway speed. Buy a replacement yoke, they're not expensive. The only way I know to break one like that is to blow a u-joint.

Larry
Title: Re: Bendix Joint
Post by: Quebec Jeep on July 06, 2012, 09:02:57 AM
I'll buy a new yoke.

Can I have a bendix style joint on one side an a spicer style on the other side? Or should I replace both for the same style?

Thanks
Pascal
Title: Re: Bendix Joint
Post by: Williamsmar on July 07, 2012, 07:32:06 PM
it must work ok, mine is like that.  i will make it right one of these days.  I think mine is a rezzepa and a bendix.  I thought it was wierd my front drivers side lugs are 3/4 and the rest 11/16.