My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: CJPilot on May 14, 2012, 04:56:41 PM

Title: Exhaust Manifold Stud Question
Post by: CJPilot on May 14, 2012, 04:56:41 PM
Anybody know what size (thread and length) the stud and bolt that hold the exhaust pipe to the exhaust manifold are? �Mine are rusted to nothing /broken. �Manifold itself is rough. �I acquired a replacement manifold but it�s been tapped oversize. I�m thinking that maybe a Keensert would work well in this application.

Thanks in advance �


Steve

1950 CJ3A
Title: Re: Exhaust Manifold Stud Question
Post by: Carls_jeep on May 15, 2012, 08:53:58 AM
One of my spare manifolds has a 5/16"x2" in it. I think it's original.
Title: Re: Exhaust Manifold Stud Question
Post by: CJPilot on May 15, 2012, 09:29:37 AM
Carl thank you for the information. �It figures, my manifold has been tapped out to 1/2-13. So a Keensert �would end up 3/8-18 or 3/8-24


Steve

1950 CJ3A
Title: Re: Exhaust Manifold Stud Question
Post by: Bob W on May 15, 2012, 11:23:37 AM
The Parts List shows...
one Bolt, hex hd, 3/8" - 24 x 1-1/4"
one Stud, 3/8" - 24 x 1-3/8"
two Nut, hex, 3/8" - 24

I think the stud may have coarse threads on the manifold side.
Title: Re: Exhaust Manifold Stud Question
Post by: CJPilot on May 15, 2012, 11:48:33 AM
Thanks Bob. �If the stud is in fact 3/8-18 at the manifold then I�ll try a Keensert and see what happens. �I have not previously used one

Steve

1950 CJ3A
Title: Re: Exhaust Manifold Stud Question
Post by: Carls_jeep on May 15, 2012, 05:58:32 PM
I'll be replacing the stud in my spare manifold. When I went out and slapped a caliper on it it read real close to 5/16" and I posted that. But the truth is it's worn out and a 3/8" nut just slides right on it. Now I'm wondering how they made that work.

Sorry about the miss info.