My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Macgraham on April 23, 2012, 08:49:14 PM

Title: priming engine oil system
Post by: Macgraham on April 23, 2012, 08:49:14 PM
I am about to start my L134 for the first time since it was overhauled in 2004. I am planning on using a grease gun which has been cleaned and screw the gun hose 1/8 in. pipe thread into the oil pressure guage outlet. Then I would pump engine oil into the oil system. I think I can put all 4 quatrs in this way if necessary but it probably isn't. How about some feedback to see if I am on the right track and not getting ready to harm the engine. Thanks.
Title: Re: priming engine oil system
Post by: Bob W on April 23, 2012, 08:54:12 PM
Sounds like a good plan to me.
Title: Re: priming engine oil system
Post by: Shalka04 on April 23, 2012, 10:23:27 PM
I'm in the same boat so to speak, except my rebuild hasn't been started since it was put together in 1990.  I like your idea but was also thinking of getting some oil onto the valves via the pcv opening on the valve cover.
Title: Re: priming engine oil system
Post by: Gunslinger on April 23, 2012, 11:18:33 PM
When I did mine we put assembly lube in the oil pump, just packed her full, then filled the oil reservoir, left the switch off pulled the spark plugs out and turned the engine over until pressure came up on the gage, then we started it.  I've never done one that sat as long as yours has, that may be different.  I have heard that assembly lube will lube the engine for 3-5 minutes with out oil flow, but I wouldnt trust that any of that is left in those old rebuilds.  Injecting it might be a pretty good idea.
Title: Re: priming engine oil system
Post by: F Bill on April 23, 2012, 11:34:20 PM
Quote
I am about to start my L134 for the first time since it was overhauled in 2004. I am planning on using a grease gun which has been cleaned and screw the gun hose 1/8 in. pipe thread into the oil pressure guage outlet. Then I would pump engine oil into the oil system. I think I can put all 4 quatrs in this way if necessary but it probably isn't. How about some feedback to see if I am on the right track and not getting ready to harm the engine. Thanks.

That is the best idea I have heard all day! (If your grease gun works with oil) .........I just might steal that one.