My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: BMIC on April 13, 2012, 07:28:29 AM

Title: OIL SEAL REMOVAL
Post by: BMIC on April 13, 2012, 07:28:29 AM
The last task after replacing parts, gaskets, cleaning, and painting my Transfer Case was to slide in new shift rod seals. Of course while seating it the rubber seal caught the shift rod cut and I mangled it. Short of taking the TC apart can I carefully drill a series of small holes in the seal to weaken it and then remove it with needle nose pliers or is drilling it too risky?     :exclamation(http://i1134.photobucket.com/albums/m606/bmic/CJ3A108.gif)]
Title: Re: OIL SEAL REMOVAL
Post by: Harveynailbanger on April 13, 2012, 10:11:52 PM
I would pull it apart. you are already there, xfer is out and accessible, no reason not too.
Title: Re: OIL SEAL REMOVAL
Post by: jamesr on April 21, 2012, 06:12:32 PM
I agree with harvey wallbanger.  No sense half assing it now.