My Willys 3A and 3B Community
3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Ranger41 on February 16, 2012, 11:19:45 PM
-
I'm considering placing an M38 top on my CJ3A - not militarizing it - I just prefer the look and function. Can anyone steer me towards measurements for the placement of the bow brackets along the body sides? Thanks.
JB
-
Hi Ranger.
I did the same. �I'm not home right now, but I can measure mine and post them later today.
I will say that mine may not be dead on spec. �I positioned the front most stowage bracket at a point where I thought the top bow looked the best when in the stored position. �
(http://i1195.photobucket.com/albums/aa397/athawk11/20120121004.jpg)
(http://i1195.photobucket.com/albums/aa397/athawk11/20120121005.jpg)
Tim
-
Okay Ranger,
Hopefully these photos help. �Keep in mind, �I started the measurement from the back of the Willys �I used a square at the back to position the tape measure.
(http://i1195.photobucket.com/albums/aa397/athawk11/bowbrkt1.jpg)
(http://i1195.photobucket.com/albums/aa397/athawk11/bowbrkt2.jpg)
(http://i1195.photobucket.com/albums/aa397/athawk11/bowbrkt3.jpg)
-
WOW! This is perfect. Thanks so much for the details and photos. That 3A looks great. Did you add the tool inserts to the tub?
John
-
Hi John,
Your welcome. �Hopefully, this helps. �The 3A, 2A �and 503 pages have been so helpful to me. �I can rarely help folks in return. �There are so many smart Willys people out there. � This was my chance to help someone else. �
I did cut my original panels and welded in the tool inserts. �I used Jpet's drawings. (2A Page). �I really liked the way the tools look hanging on the side of an old Willys. �That is probably why I ended up dressing my 3A like an M38. �Like you, I also liked the functionality and the way the M38 Top bows look. �Especially in the stored position.
Good Luck with your project.
Tim
-
This photo is from Wes over on the willysmjeeps. Very knowledgeable gent.
(http://willysmjeeps.com/v2/modules/gallery/albums/album76/Rt_Aft_Qtr_specs.jpg)
-
For the truly lazy (like myself), Beachwood sells a template of the bow and footman loop locations. Just tape it on the body, mark the holes with a Sharpie, then drill away.