My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Macgraham on February 09, 2012, 01:05:02 PM

Title: dipstick tube
Post by: Macgraham on February 09, 2012, 01:05:02 PM
Just getting engine ready to install, the dipstick tube seems to be fairly loose fit. Is there a way to seal it since there is no place for an o-ring? It came from another 134 so I thought it would be ok. Any suggestions?
Title: Re: dipstick tube
Post by: athawk11 on February 09, 2012, 02:33:08 PM
Mac,

I used Permatex 2.  It's a plyable, non hardening seal.  Worked fine.  I also used it on my spines at the transfer case, and to seal threads on the bolts.

Tim

Title: Re: dipstick tube
Post by: p3ferris on February 09, 2012, 09:33:14 PM
Just push it down and fasten the clamp tight.
Title: Re: dipstick tube
Post by: turkehunt on February 19, 2012, 04:00:14 PM
I have the same problem with no clamp @ the top The permatex 2 Sounds good  :)
Title: Re: dipstick tube
Post by: Jesse on February 21, 2012, 10:04:40 PM
I took a rounded over punch and put a few indents from the inside out on the bottom edge. Not huge dents, just 3 or 4 small ones for a tight fit. I was able to tap it in with a block of wood on the top and it is holding fine.

-Jesse
Title: Re: dipstick tube
Post by: Macgraham on February 21, 2012, 10:36:41 PM
I took a socket which fit into the tube snugly and held it in the vise and worked the tube on and off and sideways and it made a good snug fit with the block. It worked out real well. thanks for you're help.