My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Comanche_County on November 27, 2011, 09:34:16 PM

Title: Front and Rear Hub Seals
Post by: Comanche_County on November 27, 2011, 09:34:16 PM
Gents,

The part in question is a National Seal #40566. �Can't remember where the darn thing goes and I'm currently typing with my dunce hat on.... I'm fairly certain it seals the hub shaft so wheel bearing grease doesn't get flung around in the brake drum. �I thought these went with my locking hubs because I usually keep parts sorted like rabid librarian on speed and these ended up in my container with my DualMatic Lockouts. �Classic case of not remembering how to put the lego castle back together. �I'm not going to get into how many times I pulled the front and rear drums today, it was embarrassing. �But they fit the rear hubs and seem to be a fit for the front hubs also.

I took a pic next to the lockouts for comparison....
(http://farm8.staticflickr.com/7033/6413739191_d12dc50271_z.jpg)

(http://farm8.staticflickr.com/7033/6413746359_39c9dd49c1_z.jpg)
Title: Re: Front and Rear Hub Seals
Post by: Matto on November 27, 2011, 09:54:24 PM
That looks like the grease seal on the inboard side of the inner wheel bearing. Just took one of mine apart to install locking hubs. Here's a link to the Vernco site showing installation of the front hubs.
http://www.vernco.com/FrontAxle/id461.htm
Matt