My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: RandyA on June 05, 2011, 02:16:17 PM

Title: torque spec.
Post by: RandyA on June 05, 2011, 02:16:17 PM

Hey all...is there a specific torque spec. for the nut on the yoke too drive line off the transfer case??assembled e brake with all new parts, except drum ...adjusted liners snug...then backed off seven turns...wanted too make sure before i re-install u joints and shaft..as always thanks in advance for your help....

Title: Re: torque spec.
Post by: p3ferris on June 07, 2011, 05:41:20 PM

I looked and there are no specs. in 2 of my books. So just tighten them up till it is pulled back and tight.  Use your judgement.

Title: Re: torque spec.
Post by: RandyA on June 07, 2011, 09:48:44 PM

Thanks...thats what i have done...