My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Tumbleweed on February 04, 2011, 03:28:53 PM

Title: Harrison Heater
Post by: Tumbleweed on February 04, 2011, 03:28:53 PM
In an attempt to restore my '49 CJ3A, I was wondering what heater was used. When I purchased the Jeep it had a box type design with the front face sloping slightly on the top towards the back. I tried do do some research on it but I am not sure what I have. I can't seem to post any pictures so as soon as I find out how I will post them. Does the longer Harrison heater belong in these Jeeps? I am talking about the one that has a red WILLYS sticker on front of it.

Thanks,

George
Title: Re: Harrison Heater
Post by: Carls_jeep on February 05, 2011, 11:03:16 AM
In my opinion anything that was made in the years of the CJ2 and 3 would be correct. I don't know if the heaters were factory installed or not but I know a lot of dealers put them in for the customer.

Maybe Bob W can tell you for sure.
Title: Re: Harrison Heater
Post by: Bob W on February 05, 2011, 06:59:24 PM
Factory installation of the Harrison heater went back and forth. Sometimes they did install them at the factory and sometimes they left it to the dealer. In any event the factory approved heater for a CJ-3A was the Harrison. It could be installed without drilling any holes, knockouts were provided. Many different types of non "factory approved" heaters were installed in CJ-3As by dealers and owners.
Title: Re: Harrison Heater
Post by: Tumbleweed on February 07, 2011, 10:19:39 AM
Thanks, I believe that I will restore the heater and put it back in the Jeep. It was tucked up behind the dash so it does not detract from the interior like the long Harrison heaters.

Thanks again,  George