My Willys 3A and 3B Community

TECH FAQ SECTIONS => EVERYTHING ELSE, General tips => Topic started by: SteveZ on February 11, 2014, 08:24:40 AM

Title: Fluids
Post by: SteveZ on February 11, 2014, 08:24:40 AM
I am going to PM my new to me 2A and want to change all the fluids in the transmission, transfer case and front/rear differentials.

I found this at NAPA - Gear Oil, GL-1 90 Gear Oil; 80w90

I've done a ton of reading and ended up more confused then when I started :o

Am I safe to use this in all of them?
Title: Re: Fluids
Post by: garage gnome on February 11, 2014, 09:29:59 PM
Yeah, you should be fine. Thats what I use.
Title: Re: Fluids
Post by: athawk11 on February 11, 2014, 11:22:44 PM
Here at the 3A, I believe you will find that the GL1 is the recommended choice for the tranny and transfer cases.� Believe it or not, 30w non detergent oil is also a good choice.

According to the manual, the right choice for the differentials is a 90w hypoid oil.� This would be any of the current GL5 extreme pressure hypoid gear oils available at all auto parts stores.

Tim
Title: Re: Fluids
Post by: SteveZ on February 16, 2014, 10:30:26 AM
So, no GL1 Mineral Oil in the Diff's?

Title: Re: Fluids
Post by: Quebec Jeep on February 17, 2014, 04:40:20 PM
http://www.cj3apage.com/cgi-bin/yabb2/YaBB.pl?num=1373983910
Title: Re: Fluids
Post by: SteveZ on February 18, 2014, 07:18:09 AM
Not trying to get into a "lubrication" debate. But I've got a 5 gallon bucket of the Napa GL1.
So I have a clear understanding--- The GL1 goes into the Transmission & Transfer Cases but I'll need a straight 90W GL5 Hypoid Gear Oil for the Differentials correct?

Thanks again.
Title: Re: Fluids
Post by: F Bill on February 18, 2014, 08:37:38 AM
Quote
Not trying to get into a "lubrication" debate. But I've got a 5 gallon bucket of the Napa GL1.
So I have a clear understanding--- The GL1 goes into the Transmission & Transfer Cases but I'll need a straight 90W GL5 Hypoid Gear Oil for the Differentials correct?

Thanks again.

You've got it. The way I understand it and I'm no lubrication engineer, is we need the GL1 to avoid the damage a modern gear lube could do to the brass parts of our transmissions, but in the differentials the hypoid gears need a hypoid lube that will hold up under the extreme pressure between the ring and pinion. No brass in the Diff, so GL-5 is fine.

Sounds like you have a lifetime supply of GL 1.  :)
Title: Re: Fluids
Post by: SteveZ on February 18, 2014, 09:50:14 AM
Thanks again. Sorry to be a PITA!