My Willys 3A and 3B Community

TECH FAQ SECTIONS => Gearboxes and axles => Topic started by: PatrickD on April 01, 2019, 04:39:19 PM

Title: Emergency brake cleaning
Post by: PatrickD on April 01, 2019, 04:39:19 PM

Dear All,
I need to change the oil seal of the outgoing shaft on transfer box, as it's leaking into the emergency brake drum.
I have remove the 4 nuts but the rear shaft refuses to come off the drum's bolts. As I do not want to be hard on it, any recommendation to remove it. There's no rust at all.
Thanks in advance for your advise.
Patrick

Title: Re: Emergency brake cleaning
Post by: athawk11 on April 01, 2019, 05:35:55 PM

Hi Patrick,
If you have removed the 4 bolts, give the drive shaft a few good hits with a dead-blow-hammer.  It will pop right off.  Don't be shy.  It can take this kind of abuse.

You might need a puller to get the companion flange to release from the drum/transfer case.

Title: Re: Emergency brake cleaning
Post by: PatrickD on April 02, 2019, 02:25:27 PM

Hi,
Thanks for your answer. I'll be more persuasive then!
Cheers
Patrick