My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Kirkski on May 29, 2014, 08:04:08 AM

Title: Frame Restoration and Coatings
Post by: Kirkski on May 29, 2014, 08:04:08 AM
Any pointers specifically addressing frame restoration and coatings would be appreciated. After looking on the web I see a lot of opinions on POR15, Zero Rust, Rust Bullet and Rustoleum etc, little overwhelming. At this pint I was going to try and "wire wheel" my frame and coat with some kind of rust protection. My plan is to have the frame black ultimately. I might be able to get the frame sand blasted, I have to see what the expected cost would be though. Any information would be appreciated.
Title: Re: Frame Restoration and Coatings
Post by: F Bill on May 29, 2014, 10:24:02 AM
Best is to blast, epoxy prime, and enamel or urethane topcoat. Had that done to a F-100 frame in Texas and it cost $350. Got a quote for the same thing up here in the Albany, NY area and it was $750.

All the miracle paint over rust things are compromises. Many tend to work well for their users, but....they baby their projects after they finish it, so it isn't really a fair comparison to a daily driver like the jeep was formerly.


If you wire wheel, treat it with some sort of conversion coating or ospho to stop what rust remains, then prime and topcoat...


Of the paint over rust products out there I tend to like the Mastercoat silver stuff the best.....its exact name escapes me right now.
Title: Re: Frame Restoration and Coatings
Post by: Kirkski on May 29, 2014, 04:06:11 PM
Thanks for the info Bill!
Title: Re: Frame Restoration and Coatings
Post by: athawk11 on May 30, 2014, 09:32:04 PM
Quote
Of the paint over rust products out there I tend to like the Mastercoat silver stuff the best.....its exact name escapes me right now.

X2 !



I've used the Master Series Silver on two Willys frames and their Ag111 black chassis coating on the most recent rebuild.� I'm very happy with both coatings.� The black coating came in a satin finish which I prefer for an old Willys. :)


The link is below.



Tim



http://www.masterseriescoatings.com/index/



Title: Re: Frame Restoration and Coatings
Post by: Kirkski on May 31, 2014, 06:46:55 AM
Thank you Tim!
Title: Re: Frame Restoration and Coatings
Post by: SteveW on June 01, 2014, 06:41:46 AM
I used the Eastwood Chassis Black and their rust encapsulator. it was a long time ago and they have changed it a little bit. I really like it and it's not a problem with sunlight like POR is to my understanding