My Willys 3A and 3B Community

TECH FAQ SECTIONS => BODY and trim => Topic started by: terryb on January 28, 2019, 06:46:11 AM

Title: Pioneer tools
Post by: terryb on January 28, 2019, 06:46:11 AM
Good morning gentlemen. I have a question I�m hoping one of you can answer for me. My Jeep is a cj3a that has taken on the looks of an m38. My question is if I wanted to add the pioneer axe n shovel would they fit right without the indentions in the body.  Thanks again for any and all answers and help.
Title: Re: Pioneer tools
Post by: athawk11 on January 28, 2019, 06:29:29 PM
Hi Terry,
My experience is the tools will stand off the surface too much to be constrained if using the standard tool bracket mounts.  I cut the slots in.

(http://www.mywillyspics.com/images/2017/10/04/Toolindentsfitday.jpg)

Title: Re: Pioneer tools
Post by: terryb on January 28, 2019, 07:46:43 PM
Interesting idea. Something I didn�t think about. I still have plenty of paint left so that is something I might do this coming summer. Thanks for the idea and the pic. If you can post any measurements I would greatly appreciate it. Thanks again for all the help.          Terry b
Title: Re: Pioneer tools
Post by: athawk11 on January 28, 2019, 08:13:22 PM
I used "jpets" drawings shown in this post at the 2A Page.

https://www.thecj2apage.com/forums/tool-indent-measurements_topic9834.html

My one recommendation...If you do this, cut out one hole at a time. Weld in the indent, then cut out the second hole.  I cut both holes at the same time.  I had a hard time keeping the steel from warping while welding the indent in place.  If you do them one at a time, you should be able to keep the warping to a minimum. 

(http://www.mywillyspics.com/images/2017/10/04/toolindents-1.jpg)
Title: Re: Pioneer tools
Post by: terryb on January 28, 2019, 08:49:15 PM
Great pictures and very useful information. Thanks again