My Willys 3A and 3B Community
TECH FAQ SECTIONS => BODY and trim => Topic started by: trijjicon on April 07, 2017, 07:22:03 PM
-
My 3A didn't have the door-side slide channels.So Bestop made me a custom pair. When we tried to slide the door into the channel it met a very large bump about right in the middle. This is where 2 pieces of vinyl were joined. The door wouldn't slide past that. How do we solve that problem? Thnx
-
I spread the channel where the door starts in and rounded the sharp end edges with a file. It is still tight. The hole length may be need to be spread.
-
Had the same problem with mine, flare out the end of the channel and use a little bar soap to help the vinyl slide.
-
I hear what u guys r saying and I thank u for the help. I did try to spread the ends but had to continue spreading all the way up. Kinda messed up the channel trying to hold it with vise grips & with a vise. Then I couldn't get the vinyl to stay in the channel. Typical me, the more I tried to "fix" it...the worse I made it. A machinist at one of the shops I frequent, suggested why not go at it this way. Fix the vinyl, not the channel. Take it an upholster, he said. That worked out really well. Just need to fine tune it abit more & I think I'll be just fine. I'll post photos when I'm satisfied with the result. Thanks for the input.