My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Roger on February 01, 2017, 11:02:37 PM

Title: Front Floor Section Options
Post by: Roger on February 01, 2017, 11:02:37 PM

Question... I had replaced the partial floor sections on my 3A and not at all pleased with the results... warped and did not replace all of the rust.  Looking at possibly just cutting it out and welding in the full floor panel with hat channels already installed... but so far it looks like only one replacement is available... the one with either the Omix or  MD Juan sticker.  Are there any US made options that may be of higher quality?  I have been able to find some misc pieces that are made in the States that are better quality but have not found anything for the floors.  Thank you!

Title: Re: Front Floor Section Options
Post by: macrisel on February 03, 2017, 03:54:41 PM

While I haven't used them myself, I believe several people have had good luck with Classic Enterprises.

Here is their link:
http://www.classicent.com/jeep/

Good luck!
Mark