My Willys 3A and 3B Community
3A, 3B, DJ Technical Knowledge Base => "Modifications"-- Technical Questions, Answers, Incites => Topic started by: SKT on February 13, 2016, 08:38:55 AM
-
.
.
Spent a lot of time researching this to no avail; therefore I'm hoping folks here can shed some light.
Looking for the manufacturer/Company that produced the below fiberglass tub.
It was on a 1948 Willys when I purchased it.
IMO, having been around a lot of fiberglass Jeeps over the years, this one was high quality. There were no markings / branding anywhere on it; however, it has molded rear flares and a slanted fiberglass dash - which I haven't seen on any other model.
No idea what year the tub was produced, but I'd guess that it was a while ago.
Thanks a lot for the assistance!
(http://www.ewillys.com/wp-content/uploads2/2009/09/1948_cj2a_fayetteville.jpg)
(http://www.ewillys.com/wp-content/uploads2/2009/09/1948_cj2a_fayetteville2.jpg)
(http://www.ewillys.com/wp-content/uploads2/2009/09/1948_cj2a_fayetteville3.jpg)
(http://www.ewillys.com/wp-content/uploads2/2013/11/1948-cj2a-lakewheeler-nc3.jpg)
(http://www.ewillys.com/wp-content/uploads2/2013/11/1948-cj2a-lakewheeler-nc1.jpg)
(http://www.ewillys.com/wp-content/uploads2/2015/01/1948-cj2a-lakechesdin-va.jpg)
.
The below tub also appears to be from the same manufacturer (note the rear flares and slanted dash):
(http://www.ewillys.com/wp-content/uploads2/2014/01/1948-cj2a-delta-co-00.jpg)
(http://www.ewillys.com/wp-content/uploads2/2014/01/1948-cj2a-delta-co-03.jpg)
-
Is it a bobcat tub?