My Willys 3A and 3B Community
Rambling, Malarky, Rants, Etc. => Rambling, Malarky, Rants, Etc... => Topic started by: 1955CJ-5 on January 22, 2014, 07:17:57 PM
-
My 3a came to me with an aluminum half cab. Someone along the way added a heavy board that was mounted vertically between the wheelhouses and which protected the rear panel of the cab.
I pulled this off months ago and today I moved it and happened to notice that the "brackets" they used to mount it were actually placards that had been cut in half..
The Osgood company made heavy equipment....this may be a clue to why my rear springs were bent over backwards!
Any ideas?
-
Jeep a trench set up maybe
-
Maybe. That is sort of what I was thinking..
This had a rear PTO...the previous owner thought he remembered a mowing machine....
The bottom two leaves of both rear spring packs were bent over backwards....
-
The bottom two leaves of both rear spring packs were bent over backwards....
Wow, I'd like to see a picture of that.
:D
-
A mowing machine....rear spring bent...
Like this?
http://www.film.queensu.ca/CJ3B/Tech/KandKMower.html
-
Wasn't there a pull behind type, or one that mounted on the drawbar?
-
I don't see any reason why we would bent leaf spring like that but who knows.
I guess overweight on the rear is the reason. The two last leaf are not attached so they didn't bent back.
-
There were bush hog mowers that attached to drawbar
-
That could be it...I can visualize that jeep bouncing over uneven ground with some heavy mower pulverizing the vegetation...
The PTO drive shaft has dents where it hit the axle...