My Willys 3A and 3B Community
Rambling, Malarky, Rants, Etc. => Rambling, Malarky, Rants, Etc... => Topic started by: Carls_jeep on August 23, 2012, 09:01:23 PM
-
It seems Jeeps are like Pandora's box, every time you fix something it opens up another issue. I was putting rubber spacers between the frame and tub and had to remove the fuel tank to do a fix on the bolt under it. Well, the tank is patched with fiber glass so I am pulling the patch off to redo it. I will be looking for a good used tank now.
From what I have read the repro tanks are crappy and not a good fit. Next spring I will pull the tub and replace the top hats and much of the front floor and anything else that needs it.
-
I have found ANY old mechanical thing is a Pandora's box....Our jeeps are older than most of us, and have already outlasted a couple generations of used cars like most 60's 70's and 80's cars. All have made it to the crusher by now, so I think we are doing pretty good with most of them.
Heck, back in the early 80's I was refurbishing a pretty popular brand of compact car on a regular basis, had to do clutches, brakes, and frame rot repair on most every Pinto wagon I bought, but they then lasted another 50 or so thousand miles. Just the way is is with old stuff. Good thing I switched to jeeps once i got older or they woulda put me in the funny farm a long time ago.
I have a 69 Beetle with all the same typical prioblems we all fight with the jeeps. Funny thing, the 69 I had as a teenage wasn't half this worn out. Go figure... ;D I know I am still the same tough guy I was at 17. I WISH!
-
;D if we didn't love them we wouldn't own them but they should be more kind to use since we are trying to keep them alive. ::)
-
I have a 69 Beetle with all the same typical problems we all fight with the jeeps. Funny thing, the 69 I had as a teenage wasn't half this worn out. Go figure.
Well, the '69 Bus I had in the early '80s was already rotted out - Chicago winter salt, you know. POs probably never washed it - just like most POs of old Jeeps. I got it for free so no loss there. Eventually the bell crank bearing housing ripped off of the front axle - oops, no steering! Ack! Hillbilly fixed it and sold it for parts.
-
Carl,
I know that 'Box' all to well. I went out to fix the brakes...two years later I came back in with a completed project.
I bought my replacement tank from Walcks. It is actually pretty nice. The filler neck angle is dead on. I did have to enlarge the holes in my floor pan a bit. The drain and fuel line position was off a bit. (1/4"). In the tanks defense, I did replace the floor pans. I could have set them a bit off.
Tim
-
Pandoras box? That's what my doc says about me!!!!!