My Willys 3A and 3B Community

Your Projects => Non-Jeep Projects => Topic started by: garage gnome on September 26, 2013, 08:00:17 PM

Title: Latest engine project
Post by: garage gnome on September 26, 2013, 08:00:17 PM
My latest engine project is a 1925 3HP Fairbanks Morse Z, whoop dee doo, nothing special. Probably one of the most common engines around. [size=18]BUT,[/size] this one has a very rare magneto setup on it. These came with a Fairbanks brand rotary mag. This one has a conversion kit offered by Wico that uses a Wico EK mag. Anyways, it was a basket case and I got it running again. It needed some headwork, rings and needle valves for the mixer.

http://www.youtube.com/watch?v=-ZWIC0Z6Ukg
Title: Re: Latest engine project
Post by: F Bill on September 26, 2013, 08:30:54 PM
Speaking of common engines, I am spending time in Newton, IA, home of Maytag.. Local antique store has a kick start maytag small motor, wants $145 for it.. Deal or no?
Title: Re: Latest engine project
Post by: garage gnome on September 26, 2013, 09:53:50 PM
Mehh, maytags, I don't pay much attention to them things. Loud and smokey things. Is is a horizontal 1cyl, vertical 1cyl, or horizontal 2 cylinder? That is pretty cheap.
Title: Re: Latest engine project
Post by: F Bill on September 27, 2013, 07:56:54 AM
Very small one cylinder, horizontal from what I can tell. I will try to stop in there sometime and get a picture for ya. Not much bigger if at all  than a Briggs and Stratton 3hp. 
Title: Re: Latest engine project
Post by: garage gnome on September 27, 2013, 09:56:18 AM
It is probably a model 92, the most common.

model 92
(http://www.oldengine.org/members/betz/P2140015.JPG)

model 72
(http://www.rucenterprises.com/asecc-main/gallery2/images/JJmaytag-72.jpg)

model 82
(http://www.leemag.50megs.com/images/82maytag.jpg)

upright maytag
(http://www.leemag.50megs.com/images/upright50megs.jpg)
Title: Re: Latest engine project
Post by: johnrb3b on September 27, 2013, 10:41:35 AM
Hi Natei
Sounds like the engine you showed us in the shop with the pavement queen.
So it's running already? Cool.
Good to see you're still around.
Title: Re: Latest engine project
Post by: F Bill on September 27, 2013, 08:02:48 PM
Second one down is it.. And just like the one in your picture it has a blank flange with no carb......but it does have a totally different muffler thing off the other side. No spark plugs... They said they would take ten percent off the $147 which gets it down to 132.30 plus tax.
Title: Re: Latest engine project
Post by: F Bill on September 27, 2013, 08:04:22 PM
BTW I know I said it was a one cylinder but my memory unit was glitching again. IT is two horizontally opposed. I didn't find any model ID on it but it did have some magneto company and made for Maytag in Newton IA on the flywheel, which is aluminum.