The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: BillT
« on: October 16, 2018, 12:39:36 PM »

Thanks for the reply oldtime. I need to get another grease gun and keep bearing grease in it.
Posted by: oldtime
« on: October 16, 2018, 10:24:16 AM »

Yes use just one or two pumps of bearing grease on each zerk every few thousand miles of operation.
Too much grease will cause it to flow past seals and on toward  the brake shoes.
Posted by: BillT
« on: October 16, 2018, 08:46:44 AM »

The rear axle on my '52 3A has zerk fittings on the axle housing ends in the bearing area. At this point should a bearing lub or chassis lub be used? I think it is a Dana 44.