The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Rus Curtis
« on: August 07, 2019, 09:46:01 AM »

Never seen that brand before.  Looks good.  You should have a bit left over after mixing. 

My technique is to poor the remaining water into the leftover half gal antifreeze to have top-of 50/50 ready to go (just mark it so you know).
Posted by: MikeP
« on: August 07, 2019, 08:22:43 AM »

well i bought 2 jugs of this stuff and it should be the right stuff and the right amount
Posted by: Rus Curtis
« on: July 22, 2019, 04:10:27 PM »

They make commercial flush but I've heard of some using vinegar - same principal as cleaning a coffee pot.  Ingenious.

If I clean, I may do that.
Posted by: MikeP
« on: July 22, 2019, 02:23:30 PM »

all right so green stuff and distilled water and im pretty sure the system is gonna need a good flush or 2 any idea on a good product to add for the flushings so i can clean the bad stuff out
Posted by: Rus Curtis
« on: July 22, 2019, 10:23:18 AM »

I use the green type.  I don't use the red.  I also strongly suggest distilled water as it minimizes mineral deposits from electrolysis.

I prefer Prestone as it hasn't caused any problems for me and the additives will help.
Posted by: MikeP
« on: July 22, 2019, 12:03:43 AM »

ok so which is the best as ive no idea which type to use etc