The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Kirkski
« on: March 21, 2016, 02:37:48 PM »

Here are the pics of what I need help with, if anyone can...

Thanks
Kirk
Posted by: Kirkski
« on: March 19, 2016, 10:37:52 AM »

Sorry for the delay lots going on at this time in our lives. New grand baby should just about cover that...

Thanks for the pick, though mine is not quite the same as that. Mine looks more like this... Though not mine and not clear enough for me to use...

I will try to post a pick of mine on Tuesday

Thanks again
Kirk
Posted by: JeepFever
« on: March 15, 2016, 09:56:08 AM »

Kirk,   did you need any more photos?    I actually went ahead and pulled the tiller out of shed, and tilled garden for first time this year. :)   To turn in the leaves etc. on the surface.    While the tiller was out,   I snapped a couple more photos of the carb,  but have not pulled them from camera yet.

 -Ron
Posted by: JeepFever
« on: March 10, 2016, 10:49:39 PM »

A photo of carb on my tiller.   If this is same as yours, and you would like photos from different angles, let me know.

Note the brace from fuel tank to air cleaner,  :)    I added it to take a load off the carb flange.  15 years later, and everything is doing ok. 
Posted by: JeepFever
« on: March 10, 2016, 07:05:31 PM »

I have a '81 model with 6hp Tecumseh,  wonder if they would be the same?

If I don't get a photo tonite,  I could do tomorrow for sure.   

Oh,  don't laugh at my JB-Welded carb,  ;D   also broken off one time when getting too close to garage and tire dropping into "ditch".
Posted by: Kirkski
« on: March 10, 2016, 02:14:51 PM »

All,

 I have a vintage Troy-Bilt that my parents purchased new in 1972. It has a 6 HP Tecumseh engine and runs great. Trouble is, I had to replace the carb because I was not carful when put tiller back the shed and I broke an ear off of the carb..

 And now I am having an issue hooking up the carb linkage...

 Photos would be nice if anyone has any to share!
 
 Thanks
 Kirk