The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: F Bill
« on: September 27, 2013, 08:04:22 PM »

BTW I know I said it was a one cylinder but my memory unit was glitching again. IT is two horizontally opposed. I didn't find any model ID on it but it did have some magneto company and made for Maytag in Newton IA on the flywheel, which is aluminum.
Posted by: F Bill
« on: September 27, 2013, 08:02:48 PM »

Second one down is it.. And just like the one in your picture it has a blank flange with no carb......but it does have a totally different muffler thing off the other side. No spark plugs... They said they would take ten percent off the $147 which gets it down to 132.30 plus tax.
Posted by: johnrb3b
« on: September 27, 2013, 10:41:35 AM »

Hi Natei
Sounds like the engine you showed us in the shop with the pavement queen.
So it's running already? Cool.
Good to see you're still around.
Posted by: garage gnome
« on: September 27, 2013, 09:56:18 AM »

It is probably a model 92, the most common.

model 92


model 72


model 82


upright maytag
Posted by: F Bill
« on: September 27, 2013, 07:56:54 AM »

Very small one cylinder, horizontal from what I can tell. I will try to stop in there sometime and get a picture for ya. Not much bigger if at all  than a Briggs and Stratton 3hp. 
Posted by: garage gnome
« on: September 26, 2013, 09:53:50 PM »

Mehh, maytags, I don't pay much attention to them things. Loud and smokey things. Is is a horizontal 1cyl, vertical 1cyl, or horizontal 2 cylinder? That is pretty cheap.
Posted by: F Bill
« on: September 26, 2013, 08:30:54 PM »

Speaking of common engines, I am spending time in Newton, IA, home of Maytag.. Local antique store has a kick start maytag small motor, wants $145 for it.. Deal or no?
Posted by: garage gnome
« on: September 26, 2013, 08:00:17 PM »

My latest engine project is a 1925 3HP Fairbanks Morse Z, whoop dee doo, nothing special. Probably one of the most common engines around. [size=18]BUT,[/size] this one has a very rare magneto setup on it. These came with a Fairbanks brand rotary mag. This one has a conversion kit offered by Wico that uses a Wico EK mag. Anyways, it was a basket case and I got it running again. It needed some headwork, rings and needle valves for the mixer.

http://www.youtube.com/watch?v=-ZWIC0Z6Ukg