The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: RDWII
« on: August 21, 2018, 10:48:08 AM »

thank you!
Posted by: MikeB
« on: August 20, 2018, 09:33:09 PM »

Check out 

https://www.novak-adapt.com/knowledge/engines/swap-guides/chevy-buick-gm/early-cj-gm-engine-conversion/

Pretty much lays out what can be done with a flattie in terms of a engine swap.
Posted by: 64CJ5
« on: August 20, 2018, 09:12:18 PM »

I did a Pinto into my M38 and I think that an Iron Duke  would make a good one to swap in to an early Jeep too.  Should use a GM bell housing.  Check with Novak and/or Advance Adapters for information.  You could check on the CJ2a page also.
Good luck with your project.  Keep us up dated on your progress.      
Posted by: RDWII
« on: August 19, 2018, 08:28:02 PM »

brainstorming, yes, you smelled smoke. Its me thinking.

I was thinking about  engines that wouldnt require the typical hood mods that the fhead motor requires on a flattie.

My flattie is in good shape, but I enjoy these mental bunny trails...

I had an iron duke 4cyl in my boat, thought it was a solid motor. I cannot find any information on the  net about the space requirements... 

Has anyone here done one?