The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Kirkski
« on: August 30, 2015, 09:19:12 AM »

Welcome, nice to have a running Jeep, I can only dream� not for long!! :D
Posted by: johnrb3b
« on: August 27, 2015, 01:38:51 PM »

You might want to wander over to the CJ-3B forum.
They have a DJ specific section.
They might be able to give you some good serial number info.

http://z4.invisionfree.com/CJ3B_Bulletin_Board/index.php?
Posted by: Quebec Jeep
« on: July 26, 2015, 06:34:45 PM »

Welcome aboard!
Posted by: Quinton
« on: July 25, 2015, 01:20:28 PM »

Ok guys I found the serial number stamped on the frame. Can anyone help me identify ::) the actual year?? The license plate says 63...

DJ-3A
Serial number stamped on the frame is 23577
Engine serial is 3j17518??

See pics attached :-)
Posted by: Quinton
« on: July 25, 2015, 01:57:40 AM »

This is before... tomorrow sometime I'll take a few pics of my current status... I cleaned the carb and installed new points, condenser, coil, resistor, plugs, derusted the starter, cleaned the oil pan and replaced the gasket, replaced the toilet paper filter with a cartridge filter, did some temp wiring for the battery and new key start. Currently I dropped the tranny yesterday and cleaned the sludge and gears... cleaned off the surface rust. It's only been 2 weeks lol and I feel I made some serious progress!! The engine fires up!

It's missing a bunch of stuff! I wanted to join here and show the progress and I'm going to need some help figuring out what's missing and where certain hoses go...

 :D
Posted by: athawk11
« on: July 24, 2015, 09:29:08 PM »

Welcome to the 3A Page.  The Dispatcher is a cool little Willys.  Post some photos when you get a chance.

Tim
Posted by: Quinton
« on: July 24, 2015, 09:16:54 PM »

I live in Los Angeles, California.� I work for a large appliance manufacturer performing in home appliance service. I just acquired a 1963 Jeep Dispatcher (to be verified via a forum post) in need of some TLC. Can't wait to share my restoration project with everyone!

Thank you all for your expertise in advance!!