The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: tow hook
« on: July 14, 2025, 10:38:50 AM »

Quote from: Rus Curtis on July 10, 2025, 01:09:24 PM
I got a 41 in my 3B (came that way and it works) and I've been inside twice.  This stumped me as I don't recall (didn't notice) the bolt holes going through the case.   I can't initially see any problem with something like permatex on the threads.

i'd have to run to the garage , but i recall 3 of the 4 go all the way threw. the axle could be old then the jeep ? thread sealant it is :)
Posted by: Rus Curtis
« on: July 10, 2025, 01:09:24 PM »

I got a 41 in my 3B (came that way and it works) and I've been inside twice.  This stumped me as I don't recall (didn't notice) the bolt holes going through the case.   I can't initially see any problem with something like permatex on the threads.
Posted by: tow hook
« on: July 10, 2025, 09:32:08 AM »

i've just finished the rebuild of my dana 41 rear axle. I see that the bearing cap bolt holes go straight threw the case. I assume that you guys used a thread sealant on these ? there wasn't any when i took it apart.  thanks