The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: MB
« on: October 29, 2023, 06:05:54 PM »

I have a brand new hood and tailgate.  No “Willys” stamp.  Located north of Chicago.
Posted by: Rus Curtis
« on: September 07, 2023, 09:26:18 AM »

Sounds good.
Posted by: Cheapsnake
« on: September 06, 2023, 08:05:06 PM »

Thanks Rus, and I agree, bracing would be essential to keep it in shape.  I'd be happy to pay you to brace it as long as shipping isn't too crazy.  That said, let me see if something comes up a little closer to home. If not, I'll be in touch.
Posted by: Rus Curtis
« on: September 06, 2023, 03:26:47 PM »

I have one.  But, the distance may be too far/shipping too expensive.

I have a stamped aftermarket I was prepping to use but in the middle of the body work (see photos below), found another used hood. So, I have this aftermarket extra.

It's located in Alabama.....

The one change I made to it is replace the hinge/rear support with an original (2nd photo). I thought the aftermarket hinge didn't sit right and was attached to the hat channel support - so just replaced both.  Not welded yet, just screwed in.

They currently cost over $400.  I bought it in '05 for $250.  I could see it go for $200 + shipping.  Shipping would be a challenge as it would need bracing to keep it in shape.
Posted by: Cheapsnake
« on: September 06, 2023, 10:32:12 AM »

Needs to be in decent, not perfect condition.  Willing to ship or can travel 100+ miles from ME WI.