The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Mayberry
« on: May 18, 2023, 08:35:19 PM »

I meant to show the plate on the engine holes didn’t match the bell housing.
Posted by: Mark W.
« on: May 16, 2023, 09:30:18 PM »

You show a photo of the bell housing and then clutch parts. The clutch parts don't care what the bellhousing or the rear engine plate looks like. But there are different bell housings (yours appears to be a later CJ-3A or M-38. The earlier 2A has a hole in the center of the starter bell for the bushing to fit into.
Posted by: Mayberry
« on: May 15, 2023, 08:48:19 PM »

My bell housing doesn’t appear to match with the plate on my engine. I’ve looked and see different plates were available but does my bell housing have the right number of bolts. My input shaft is a 10 spline, so is the engine. I didn’t think to measure the input shaft length or diameter when I took the pic.