The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Mark W.
« on: August 04, 2022, 08:59:16 AM »

Use the PCV line.
Posted by: Shark49
« on: August 04, 2022, 06:30:38 AM »

Not sure.  The idea is to use vacuum to suck the fluid into the valve area to clean them.  I could simple pour it into the oil right before I'm ready for an oil change but that's not the same either.
Posted by: PercyUK
« on: August 02, 2022, 12:24:56 PM »

Hi Nate, I guess you could try going through the spark plugs. Pour something in and turn it by hand a few times. Leave it for a while then run it up?
Posted by: Shark49
« on: August 02, 2022, 06:10:05 AM »

guess no-one  ;D
Posted by: Shark49
« on: July 19, 2022, 08:29:20 PM »

On my old Chevy 250 Inline 6, I periodically use the sea foam engine clean trick.  Warm the engine up, unhook vac line to carb from valve cover, and pour in sea foam slowly while engine still running until its all in there.  Let sit for 30 minutes, start it up and let it burn the carbon off the innards.   Works like a charm on the upper engine and valves IMHO.  Learned it from an old mechanic when I had my '69 Triumph GT6.

Is there a similar way people do this on a Flathead L134?  I suppose using an engine flush and changing the oil more often would be one way but not sure about the upper end since there isn't a vac line to use. My engine runs very solid with high compression and is probably a rebuild but not knowing much about it want to do something.

Thanks in advance.
-Nate