The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Kirkski
« on: August 22, 2014, 09:52:39 PM »

Welcome, looking forward to pics!
Posted by: Quebec Jeep
« on: August 21, 2014, 09:12:56 PM »

Welcome here! We like pictures....post it!
Posted by: BMIC
« on: August 19, 2014, 06:19:23 AM »

Welcome Mike, My grandfather was from Sheepscot, I have been to Bristol many times. Looking forward to your build and the pic's.
Posted by: athawk11
« on: August 18, 2014, 08:38:11 PM »

Hi Mike,
Welcome to the site.  Garage Gnome has a pretty big engine in a Willys he calls "The Jalopy".  I'll bet he'll have some tips for you.

Tim
Posted by: Mike Cuff
« on: August 18, 2014, 05:32:28 PM »

Hello All,

Over the last 15 years I�ve owned several Jeeps including a heavily modified TJ and a fully restored Hotchkiss M201 (Willys MB built under licence in France in the 50s).  Joining the forum as I am at the very early stages of planning a CJ3A/M38 build (I have a chassis and a front D44), if possible using a 4.3L V6 Vortec from 2001 Chevy Blazer.  I know these engines pretty well, as I�ve recently stuck one in a Buggy that I�m currently finishing.  Looking to make contact with somebody who has already used the same engine in a CJ3A/M38 build as I have a lot of questions such as how they handled an engine height of 32 inches.
 
Mike C aka Cuffy