The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 1955CJ-5
« on: February 24, 2021, 06:04:43 PM »

Several years ago, ( probably about 50) after we ripped the side mount spare off on a tree, the fellow who helped my dad with equipment maintenance on the ranch came up with a similar solution for the spare. I have since replaced the side mount, but left this on "just in case" :)

The other section has the center part of the hinge along with the wheel mount bracket and the upper part was bolted through the tailgate. You could swing it down if you wanted to open the tailgate.
Posted by: Rus Curtis
« on: February 24, 2021, 10:35:33 AM »

It’s the hinge for a tailgate mounted spare carrier that swings down.

Quote from: Mytwojeeps2020
Well, I’ll be danged. I’d never though of that since the CJ came with a spare tire side body mount. Thanks!

I had to dig around in my saved jeeps photos to find these from an early CJ-5.  Not sure where I found it but look closely at the hinge - looks similar to what you posted. 

Also:
https://cj3b.info/Owners/Ogletree/TireCarrier.html
Posted by: Mytwojeeps2020
« on: February 24, 2021, 10:11:56 AM »

Well, I’ll be danged. I’d never though of that since the CJ came with a spare tire side body mount. Thanks!
Posted by: oldtime
« on: February 24, 2021, 09:29:53 AM »

It’s the hinge for a tailgate mounted spare carrier that swings down.
Posted by: Mytwojeeps2020
« on: February 24, 2021, 08:36:59 AM »

This is on the rear of my CJ5. This small round bar “thingy” above the drawbar looks like it was deliberately incorporated into the drawbar mount. The PO who had it for the last twenty years did’t know what was either.