The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: dluyk
« on: September 11, 2020, 09:39:31 AM »

Thank you so much for the help. At one time I had the
manual downloaded - where it went - who knows. Your tips are so helpful.
Can't than you enough.
Posted by: Rus Curtis
« on: September 10, 2020, 10:45:41 PM »

dluyk,
I literally had questions just like this from front to back and top to bottom.  This is why I purchased a Parts Manual.  They really come in handy.  Oldtime's got you fixed up.

FWIW, by the time I'd gotten all the paint on, I found out chasing the threads with a tap helped.
Posted by: oldtime
« on: September 10, 2020, 09:40:48 PM »

Typical grade 5 bolt.
3/8” x 1-1/2” x 24 national fine thread plus a large washer
Qty. of 4 required.
Posted by: dluyk
« on: September 10, 2020, 09:06:38 PM »

This screw holds the front fenders to the frame. I've looked on line, but
don't know what to call it in my search. I need to replace them, but don't even know where to start.
I sure could use your help on this - and thanks in advance.