The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: SteveKfl
« on: June 26, 2020, 05:17:09 PM »

Have you considered oversized 1" wide lug nuts...  https://www.jegs.com/p/JEGS/JEGS-1-Hex-Lug-Nuts/1528580/10002/-1
Posted by: locomotive2111
« on: June 26, 2020, 03:40:55 PM »

I have seen these rim holes fixed by welding them to build the metal up then redrill  the hole most small machine shops could do this in one or all 5 of the holes
Posted by: Brad Y.
« on: June 10, 2020, 11:04:52 AM »

So previously to my owning them the rim was over-tightened due to the left hand thread. The rim now has the nut opening larger than it should be. I thought at one time I found a page showing someones repair for this but can no longer find it. Does anyone know of a website showing how to repair this type of problem?

Thank you in advance.