The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Hamhog
« on: May 22, 2020, 03:45:38 PM »

Found.
Posted by: Hamhog
« on: April 22, 2020, 09:46:15 PM »

Appreciate it, but I'm looking for the specific tool.  Thanks.
Posted by: binthere
« on: April 20, 2020, 05:39:56 PM »

The tool I use to remove seals is a small wrecking bar or a big screwdriver because the seals are no good anyway, and the tools are cheap!
Posted by: Hamhog
« on: April 20, 2020, 04:19:35 PM »

I'm looking for the tool used to remove the front and rear output seals on a D18 t-case.  If anybody has one to sell or loan, please let me know.  From what I've found, it's a Miller tool with part numbers W-251 or C-748.  Thanks.