The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: SteveW
« on: April 28, 2020, 07:46:49 AM »

Can affirm it has been an indispensable tool to have. I have a fixed vise on a workbench but being able to roll this around is a big plus and it really a solid lock when you tighten that wheel. Have to figure out how to make something to hold larger items deeper into the opening using those lower 1/2 round channel's.
Posted by: SteveW
« on: August 26, 2019, 09:20:22 PM »

Well it is back at work. My new workshop is just the ticket for it and I am using it



Posted by: johnrb3b
« on: October 22, 2013, 09:06:07 AM »

Yeah, cool.
Posted by: garage gnome
« on: October 19, 2013, 08:15:10 AM »

Thats is pretty cool!
Posted by: SteveW
« on: October 18, 2013, 10:16:20 PM »

I have had this for a few years but no room to set it up and use it. Quite a neat rig for it's time and actually was very popular in Australia with sheep shearers. I don't have the crank or the vise and there is also a tray that water could go in while using the stone to sharpen items. It almost went to junk yard when a man I went to Church with passed away and he had 3 daughters who just wanted the house cleaned up. He was a handy man of the highest order and to think how much stuff did get pitched but at least something survived.









http://www.youtube.com/watch?v=CyMZHajdquE