The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: squidtone
« on: October 04, 2017, 11:27:36 AM »

Awesome! Great pic, thanks!
Posted by: mtnman37879
« on: October 04, 2017, 06:38:17 AM »

Yes there are stiffeners under the brackets. Here's a picture.
Posted by: squidtone
« on: October 03, 2017, 10:04:30 PM »

Hey folks,
This one is pretty obscure:
I'm thinking I remember seeing some sort of stiffener plate on the under side of the center top bow pockets...they were welded to the underside of the wheel wells directly under the bow pockets.
Can anyone confirm this on their original tub?

I've attached a picture with some bow pockets I fabricated using my very rusted originals as guides..(I think they're close enough) But please note the piece of manila folder cut to a size I'm guessing would be this "stiffener" plate that I think I'd like to weld to the underside of the wheel well.

The wheel well sections I removed were so bad there I only saw a hint of what I surmise to be these "plates".

Just sorta wondering if I'm on the right track by putting something like this in.

Thanks.