The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Devin
« on: April 28, 2017, 06:14:52 PM »

Thanks for tge measurements. Just Seems like the gap is to big for the seal.  :-?  The gap in the seal between the glass and flange is only like 5/16 with the lock peice in. Maybe my seal is wrong.
Posted by: scoutpilot
« on: April 28, 2017, 05:06:27 AM »

Best to only install the glass once. Square away the frame, paint and all, then install the glass. Even if the glass is wrong, you�ll have to do it anyway.
Posted by: Devin
« on: April 28, 2017, 01:28:39 AM »

I guess I'm in the ballpark. I measured again and got a clearance of .312 top and bottom. And the sides are right at .375 (3/8").  Think there would be any harm in test fitting the glass, then removing it for paint? Seal and glass is from walck's
Posted by: athawk11
« on: April 27, 2017, 11:18:02 PM »

Some additional numbers for comparison...

Original frame:       49-9/16" x 13-1/2"
Glass (not original): 48-7/8" x   12-7/8"
Posted by: squidtone
« on: April 27, 2017, 08:41:36 PM »

By circumstance I am currently refurbishing my '50 CJ3A windshield. It is the original unit, and I daresay it has it's original glass too:
"Guardian SafetyPlate
AZ Hi-Test WZ
50".
I'm suspecting the "50" is the year of manufacture for this glass??...
Anyway, I took the glass out of the frame and measured this:

Clear opening between the metal frame flanges:
49-7/16ths" X 13-5/8ths"
This measurement was very consistent all the way across and up and down. (It's a very good stamping whoever did it for Willys)

The glass measures:
48-3/4ths" X 12-3/4ths"

So the glass to metal gap was 7/16ths" on the top and bottom, and a tiny bit under 3/8ths" on each side.

Hope this helps.
Posted by: Devin
« on: April 27, 2017, 03:46:51 PM »

Did some searching around but can't find a solid answer. Need to know what the clearance between the windshield glass and frame is without the gasket. Junk MDjuan frame seems the hole they cut is to big. I already welded a strip in so now I have like a 3/8-1/2" gap. What is it supposed to be? Thanks yall.