The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: oldtime
« on: March 28, 2017, 08:07:47 PM »

Yes they can certainly be interchanged but you do have to address the possible differences concerning axle shaft end float adjustment.
Posted by: PaulS
« on: March 28, 2017, 06:45:24 PM »

Can they be interchanged in an axle?  I can't use the Rzeppas from a 27 to replace the Spicers in a 25, can I?

-Paul
Posted by: oldtime
« on: March 27, 2017, 12:29:13 PM »

To me it's kinda funny how everyone seems to be searching for Spicer shafts when Rzeppas are a superior design.

Posted by: Carls_jeep
« on: March 27, 2017, 09:36:47 AM »

After looking at the Bendix and Rzeppa I agree. I just sent you a PM.
Posted by: Bob W
« on: March 27, 2017, 08:52:42 AM »

I think the Rzeppa are far superior to the Bendix joints.
Posted by: Carls_jeep
« on: March 26, 2017, 05:37:00 PM »

Well Oldtime, I read your post on CJ2 and posted there and totally agree with you. I want and need a constant velocity joint and the Rzeppa is the one and only one for the CJ2 and 3. I have a Lock Right in the rear axle and it made a 100% improvement in traction on hills.

On the Hole in the Rock trail I impressed the $60,000+ Chrysler's and Fiats that are called Jeeps but really aren't.   ;D
Posted by: oldtime
« on: March 26, 2017, 02:48:13 PM »

In actual use I have run all 3 types of axle shafts.
In 1985 I went exclusively to Rzeppa joints in my Dana 25's.
I ran them with Power Loks and had zero problems
Very soon I'll be converting back to Dana 30's and Spicer type joints.

It's my opinion that Rzeppa shafts are the absolute optimum for anyone with D25 or D27 steering axles.
IMHO the Bendix are the worst.

Desireability pretty well follows the maximun steering angle specifications.
Bendix = 23*
Spicer = 27-1/2 *
Rzeppa = 29*

Bendix and Rezeppa are constant velocity type universal joints. The single Spicer Cardan cross is not a constant velocity design.
Posted by: Carls_jeep
« on: March 26, 2017, 12:22:07 PM »

What do ya'll think about the Rzeppa axle shafts? I am planning to use a pair I have.