The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: PaulS
« on: June 06, 2016, 10:11:12 AM »


How do you disassemble a Willys water pump?  The shop manual says to pull the clip out and then use an "appropriate puller" to remove the pulley and impeller.  Are those just pressed onto the shaft?

When I tried to pull the impeller, it broke.  (It seems to be included in the rebuild kit that Walcks sells, so no big deal, if I can complete the disassembly with no further damage.)

Any suggestions?

Thanks,

-Paul