The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Ryan_289
« on: April 06, 2016, 09:07:36 AM »

Jim did you get a body kit?  The oddball looking bent cowl seal that came with my kit was crap.  I got one of the better ones from Ron Fitzpatrick.  I had my old windshield frame to compare but I centered mine and drilled and screwed from the center out to keep it tight.  I did have to trim some of the ends down so the windshield would clear the cowl when closed.
Posted by: JimVillers
« on: April 06, 2016, 08:42:52 AM »

I am looking at the cowl seal that came with my new tub and windshield and thinking that there mus be a trick to its installation.  The parts manual has 17 pan head screws; the windshield frame of course has not holes and the rubber seal is very stiff.

I would appreciate a picture or two that shows the installation and any tricks that you may have on locating the seal/holes.