The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: athawk11
« on: March 29, 2016, 11:43:50 AM »

Hi Jim,

Below are a few reference photos.� On first view, your seat looks like it needs to be moved away from the tub wall.�

Additionally, it would not be unheard of to have to "adjust" the seat frame a bit to achieve a good alignment.

Please note:� These are 2A seat frames in a 3A Willys.� The legs mount in the same position either either way.� The seat just doesn't reach back far enough to sit on the front of the wheel house.� I had to add larger shelves shown in the last photo.












Posted by: JimVillers
« on: March 29, 2016, 09:52:34 AM »

Locating the driver's seat just does not "feel" correct so I thought I would post a couple of pictures to get a second opinion.   The issue is that the inside rear foot sits on top of a ridge in the tub and the bolt hole is at the edge of the deck.  The frame is 3 1/4 inches from the outside wall. The front feet look like they are in a good location.