The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: malcomstrenko
« on: January 13, 2013, 02:54:30 PM »

Jamesr, yes thanks, planning to do tune up [someday]. Meanwhile, I'm about to try to post some pics in the "stock" section of the page to show stuff I'm working on.\
Posted by: jamesr
« on: January 13, 2013, 08:41:54 AM »

Quote
� � � � � � � � � �


� hope this works?
Could probably use a tune up!
Posted by: AZJeepNut
« on: January 06, 2013, 09:02:34 PM »

That's gonna help a lot, thanks! Nice pics, too.
Posted by: Ryan_M
« on: January 06, 2013, 06:53:57 PM »

It is a valve for the heater hose. There is usually one there and another hose connection on the top of the water pump. A hose runs from each back to the heater if you have one. Most heaters were mounted to the firewall under the dash on the passenger side.


Posted by: AZJeepNut
« on: January 06, 2013, 06:05:07 PM »

Looks like it worked just fine! By the way, from one newbie to another, if you know what that brass piece with a valve * at the top, located on the head at the back edge, with a hose attached, might be, I'd sure like to know. I've got one of those on the engine in my 1950 CJ3A. I thought it might be a connection for a heater, but there's no hose on mine so I can't figure out where it might have connected. Got any ideas?
Posted by: malcomstrenko
« on: January 06, 2013, 05:52:29 PM »

� � � � � � � � � �


� hope this works?