The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: specialty
« on: February 11, 2016, 02:53:40 AM »

Serves the purpose I guess. I might just see if I can find a sealed bearing to do the job or make up a oil-lite bushing. Thanks for the information, now I know what was in there.
Posted by: 1955CJ-5
« on: February 10, 2016, 08:46:49 PM »

Glad to have been able to help!

They are not the greatest bearing but they don't carry much load....a little light grease when you put it together and it should work fine...
Posted by: specialty
« on: February 10, 2016, 07:57:03 PM »

After seeing your pictures I am missing about all of it. The only piece I have is the one that taps into the column. Thanks
Posted by: 1955CJ-5
« on: February 10, 2016, 10:19:15 AM »

Here is one that is apart...

Maybe you are missing part of it?

Posted by: garage gnome
« on: February 10, 2016, 06:03:45 AM »

I suppose you could make one from bearing bronze.
Posted by: specialty
« on: February 09, 2016, 07:48:48 PM »

You can do a google search to find a picture. My column has one in the top but unless I am missing part of it it does not touch the column at all and does nothing. It looks like the picture though.
Posted by: garage gnome
« on: February 09, 2016, 01:11:50 PM »

What does the stock bearing look like?
Posted by: garage gnome
« on: February 09, 2016, 01:10:52 PM »

Can't help you on the bearing, but you can install the column after putting the tub on. That's what I do. The hole is slightly small for the triangular piece, but you can make it fit.
Posted by: specialty
« on: February 09, 2016, 06:17:56 AM »

Question on the top steering column bearing. Those ones that you can buy look pretty weak to me. Anyone ever make one out of bearing bronze or oil-lite to make a good durable bearing? Or maybe a good sealed bearing to replace the original?
Also should I go ahead and install the column
BEFORE putting the tub back on? I notice most have their columns installed before. It looks like it would be much easier to do it before to get everything adjusted right than after. Thanks