The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: dat
« on: March 20, 2015, 09:19:32 AM »

thanks,  I've had good luck with Walcks, haven't delt with Herm, but it looks like it could be a good idea
Posted by: 1955CJ-5
« on: March 18, 2015, 06:04:13 PM »

I bought the Novak intermediate shaft and bearing kit....the bearings appear to be the same as you get with any intermediate shaft kit.

The shaft is nice. It's cut for "O" rings to seal at each end....however it is really difficult to install without cutting/slicing/ruining the "O" rings....

I put the one I got from Herm back in and it's fine....

I got both my transmission and TC rebuild kits from Herm....

http://hermtheoverdriveguy.com/

But if I remember right the gasket kits and seals that Herm sent were Crown products.
Posted by: PeterL
« on: March 18, 2015, 05:37:09 PM »

I bought into the Novak hype.  I can say with 100% certainty it is hype.  Many of the parts had the crown label scraped off.  I would certainly buy their hardened shaft.  All the rest I would buy elsewhere.

My 2 cents from buying their stuff 8 last August. 
Posted by: dat
« on: March 18, 2015, 03:37:51 PM »

looking at transfer case rebuild parts and kits, novak is almost twice as much as either Walcks or Kaiser,  are their parts that much better?    or are they about the same quality?