The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 1955CJ-5
« on: March 09, 2015, 10:40:48 PM »

Are you using a fish weighing scale to set the preload? Seems to me it's 12 to 16 pounds pull without the knuckle seal in place....

Posted by: Birddog7
« on: March 09, 2015, 10:37:55 PM »

Been trying to set the preload. I even removed all the shims and still can move the knuckle. Could the male side of the knuckle were the bearing races go be bent? The Pax side set up ok.