Posted by: 1955CJ-5
« on: December 20, 2014, 10:15:44 AM »Quote
these seem to be something like 29/32" inch hex size,
They are an odd size for sure....I thought my new ones were poorly made but the old ones were the same.....23mm maybe?
Welcome to our new forum software.
We are now using SMF instead of YaBB.
these seem to be something like 29/32" inch hex size,

Original shackle thread direction can be identified by the markings on the nut. Use a lot of heat and try turning the nut in both directions just to help break it loose. If that doesn't work cut off the U and try to screw the bushing out. Worst case the spring hanger can be replaced on the frame. Two rivets and a few short welds is all that's holding it on.

