Posted by: athawk11
« on: August 09, 2014, 08:48:28 AM »Paul,
I have had this same conversation a few years back.� You aren't finding a nut for the end of your 25, because there wasn't one on it.� It is not required with certain locking hubs.� There was an old hub instruction sheet that said you could, or should cut the threaded part of the axle off for fitment reasons.� I can't find that sheet now.� I think I saw it at the 503 web site.� ��
I have Warn hubs on both '49 3As.� Both are the old school axles.� Neither have nuts.� Both perform flawlessly.� Both are a Warn hub design that are long, and allowed the POs to leave the threads on. There is no room inside the hub for nuts.




Hope this puts your mind at ease.
Tim
I have had this same conversation a few years back.� You aren't finding a nut for the end of your 25, because there wasn't one on it.� It is not required with certain locking hubs.� There was an old hub instruction sheet that said you could, or should cut the threaded part of the axle off for fitment reasons.� I can't find that sheet now.� I think I saw it at the 503 web site.� ��
I have Warn hubs on both '49 3As.� Both are the old school axles.� Neither have nuts.� Both perform flawlessly.� Both are a Warn hub design that are long, and allowed the POs to leave the threads on. There is no room inside the hub for nuts.




Hope this puts your mind at ease.
Tim