The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: June 16, 2014, 03:25:51 PM »

The pitting won't hurt anything but how is the race where the needle bearings go? If it is not pitted use it.
Posted by: macrisel
« on: June 15, 2014, 11:12:54 PM »

I need some expert opinions on the teeth on my input shaft.� Are these teeth bad and need replacing or am I being too picky?




Also, I had a little bit of pitting on the shaft.� It is in front of the bearing and the felt seal and I'm not sure if it is a big deal or not.� It is pretty hard to see in this photo.....


One of my roller bearings looked like it had gotten caught between some gears...


My cluster gear looks worn, but according to Rick's guide I can clean it up with a file and re-use it...


Finally, a little glamour shot of the parts and pieces all cleaned up and organized..